This compressor is ideal for carpenters, builders, interior designers/decorators working on commercial sites that are covered by HSE lowest possible voltage directives, where portability is may be a requirement. The compressor is especially suited for use with air staplers,18g Brad nail guns, low pressure spray guns, paraffin guns and car/van tyre inflators as well as touch-up/air brush spraying applications. The oil filled Aluminium cylinder head with cast-iron cylinder gives slightly higher output than the Oil free equivalent as well as added resistance to wear over time. The compressor is also fitted with a 2.0hp induction motor for reliable and quiet operation as well as having a fully automatic pressure cut-out switch and air regulator with twin gauges displaying tank and output working pressures. The compressor is fitted with wheels to give greater portability and can be transported on its side if required. The Precision welded receiver tank is manufactured to comply with the latest European standards (Pressure Vessel Directive 2009/105/EC). This unit is supplied with a BS EN 60309 approved yellow 3 pin 110v 16A plug. Please Note: A 5.0Kva 110v Transformer or a minimum continuous rated 6.5Kva Generator will be required to power this compressor in 110v.
Compressor 24L / 2hp - 110v
- Technical Specification: Motor Output: 2.0hp Voltage/Phase: 110V - 1ph Rated Supply: 13A Air Displacement(Input): 6.8CFM (193 ltr/min) Maximum Free Air Delivery (Output@90psi): 4.7CFM (130 ltr/min) Maximum Pressure: 116psi/8bar Receiver Capacity: 24 ltr Dimensions (W x D x H): 600 x 290 x 585mm Weight: 27kg Please Note: A 5.0Kva 110v Transformer or a minimum continuous rated 6.5Kva Generator will be required to power this compressor in 110v.